HOW TO DEAL WITH THE EARLY AND LATE WEAR AND TEAR OF CHILDREN'S AMUSEMENT EQUIPMENT

2018-10-05 20:34:10 admin 1

Children's amusement equipment is a popular item at present, but most of the equipment is mechanically powered and is made up of different parts, so there is a point of wear and running-in. I believe that everyone should have common sense in this respect. Whatever is new, everything needs to be running-in, and by the end of the year, it will be necessary to prevent its wear and tear, and the amusement equipment will also be like this. If the run-in of the early stage and the wear and tear of the later period are not well controlled, then it is easy to affect the service life of the whole equipment. Of course, this point will be reminded by the regular manufacturers when buying, but many customers do not think so. This is a very bad phenomenon, here to give you a brief introduction, after the purchase of equipment how to handle the running-in and anti-wear related problems, the details are as follows.

As we all know, no matter what, the new ones have to have an adaptation period. After the children's amusement equipment has just been bought back, because all the points of convergence are new, it is said to be a healthy run-in, which is like a car. After the new car run-in can be better on the road, but also more fuel savings. The same is true of the amusement equipment, the pre-running-in needs to do a lot of things, or in the operation of more worry, lubrication done in place, need not take too much time to be able to run in place. After basically no problem, but usually also should pay attention to maintenance. The running-in of the early stage is relatively simple, but the later period of anti-wear is more complicated. Of course, what we should introduce in detail is also the knowledge of anti-wear, hoping that it will be helpful to the vast number of customers. Make their own products can be used for a long time without problems, better create benefits.

  After the children's amusement equipment is used for a period of time, there will be different degrees of wear in every joint. Of course, this wear is normal, and every device will have such problems. However, the difference is that if the maintenance is good, it can be used for a long time. If the maintenance is not good, the service life of the equipment will be seriously affected, and even all kinds of safety accidents will occur. This requires equipment maintainers to regularly check the lubrication of individual parts, as well as the looseness of screws, which are so important that once problems are detected, they must be corrected in a timely manner. This ensures that the equipment runs for a long time without problems. However, if we do not pay attention to maintenance at ordinary times, it is easy to have problems with what we have said above. The light will affect the life of the equipment, and the heavy will break down while passengers are on board. It is easy to cause safety accidents. Therefore, we should pay attention to this point, although it is troublesome. But it is this kind of detail that determines the operation of the device as a whole, and don't belittle it.

купить смартфон самсунг
гостиницы Ялты